P 6
Please retain product label and instructions for future reference
Felt
tacks
1
2
50
mm
50
mm
50
mm
3020mm
1000mm
1420mm
50
mm
Step 12
Parts needed - No. 29 QTY 1
Cut three strips from the roll of felt
(No.29)
, 2x3020mm and 1x1420mm in
length. Place felt on top of roof sheet and
align as shown in diagram ensuring strip 3
over hangs the front by 50mm with equal
spacing at each corner.
*Ensure strip 1 is the first piece placed
down then lay sheet 2 and then 3. Make
sure each sheet overlaps the next by at
least 100mm creating a run off.
Use a fascia as a guide to mark out the
angled cuts including 50mm overhang.
Cut the sides as shown in diagram at the
dotted lines, use fascia width as a cutting
guide. Cut the triangle with 50mm
overhang again using fascia as a guide.
100x Felt Tacks
29
Fr
ont
Corner
Corner
Triangle
3
HANDLE
WITH CARE
1
2
3
4
17
17
17
17
40mm
screw
Pre drill
hole
Step 13
Parts needed - No. 16 QTY 4
Attach the cover trims
(No. 17)
to
each corner of the building using
3x40mm screws per cover trim.
12x40mm Screws
It is ESSENTIA
L that
you ap
ply wood treatm
ent
15
15
16
16
16
Step 14
Parts needed - No. 15 QTY 2
No. 16 QTY 3
Fit the fascias
(No. 15 & 16)
to
the building over the felt and
secure in place with 40mm
screws as shown. Cut to length
where necessary. Pre drill to
avoid splitting.
Make sure the fascias at the back
of the building fit lower than the
roof height to allow water to run
off.
17x40mm Screws
40mm
screw
Pre drill
hole
*
Cut down
trims to fit
