door opener, contact an authorized Mercedes-
Benz Center.
Alternatively, you can call the following tele-
phone assistance services:
R
USA: Mercedes-Benz Customer Assistance
Center at 1-800-FOR-MERCedes
R
Canada: Customer Service at
1-800-387-0100
R
HomeLink
®
hotline 1-800-355-3515 (free of
charge)
More information on HomeLink
®
and/or com-
patible products is also available online at
http://www.homelink.com.
Notes on the declaration of conformity
(
Y
page 26).
USA: FCC ID: CB2HMIHL4
Canada: IC: 279B-HMIHL4
Important safety notes
G
WARNING
When you operate or program the garage door
with the integrated garage door opener, per-
sons in the range of movement of the garage
door can become trapped or struck by the
garage door. There is a risk of injury.
When using the integrated garage door
opener, always make sure that nobody is
within the range of movement of the garage
door.
G
WARNING
Combustion engines emit poisonous exhaust
gases such as carbon monoxide. Inhaling
these exhaust gases leads to poisoning. There
is a risk of fatal injury. Therefore never leave
the engine running in enclosed spaces with-
out sufficient ventilation.
Programming
Programming buttons
Pay attention to the "Important safety notes"
(
Y
page 285).
Garage door remote control
A
is not included
with the integrated garage door opener.
X
Turn the SmartKey to position 2 in the ignition
lock (
Y
page 136).
X
Select one of buttons
;
to
?
to use to con-
trol the garage door drive.
X
To start programming mode: press and
hold one of buttons
;
to
?
on the integrated
garage door opener.
The garage door opener is now in program-
ming mode. After a short time, indicator
lamp
:
lights up yellow.
Indicator lamp
:
lights up yellow as soon as
button
;
,
=
or
?
is stored for the first time.
If the selected button has already been pro-
gramed, indicator lamp
:
will only light up
yellow after ten seconds have elapsed.
X
Release button
;
,
=
or
?
. Indicator
lamp
:
flashes yellow.
X
To program the remote control: point
garage door remote control
A
towards but-
tons
;
to
?
on the rear-view mirror at a dis-
tance of 2 to 8 in (5 to 20 cm).
X
Press and hold button
B
on remote control
A
until indicator lamp
:
lights up green.
When indicator lamp
:
lights up green: pro-
gramming is finished.
When indicator lamp
:
flashes green: pro-
gramming was successful. The next step is to
synchronize the rolling code (
Y
page 286).
X
Release button
B
on remote control
A
for
the garage door drive system.
If indicator lamp
:
lights up red: repeat the
programing procedure for the corresponding
button on the rear-view mirror. When doing
so, vary the distance between remote control
A
and the rear-view mirror.
The required distance between remote con-
trol
A
and the integrated garage door opener
depends on the garage door drive system.
Features
285
Stow
age
and
features
Z
