Marco Polo seat/berth combination
Important safety notes
G
WARNING
The seat belt does not offer the intended level
of protection if you have not moved the back-
rest to an almost vertical position. When brak-
ing or in the event of an accident, you could
slide underneath the seat belt and sustain
abdomen or neck injuries, for example. This
poses an increased risk of injury or even fatal
injury.
Adjust the seat properly before beginning
your journey. Always ensure that the backrest
is in an almost vertical position and that the
shoulder section of your seatbelt is routed
across the centre of your shoulder.
The seat/berth combination can accommodate
two persons. You can adjust the seat backrest
angle and the seat/backrest contours electri-
cally. If you adjust the seat backrest to the hor-
izontal position, together with the bed exten-
sion, you will have a full-length bed. Do not drive
with the backrest reclined too far back.
Also observe the basic information and safety
notes on seats (see the vehicle's Operating
Instructions).
Adjusting the seat backrest and cush-
ion contours
G
WARNING
When adjusting a seat, you or another vehicle
occupant could become trapped by the guide
rail of the seat, for instance. There is a risk of
injury.
Make sure that no one has any part of their
body within the sweep of the seat when
adjusting it.
G
WARNING
If children adjust the seats, they could
become trapped, especially if they are unat-
tended. There is a risk of injury.
When leaving the vehicle, always take the key
with you and lock the vehicle. Never leave
children unattended in the vehicle.
i
If the switches are pressed more than once
in an uncontrolled way, for too long or in quick
repetition, a play-protection feature blocks
the function of the switches. After one
minute, the play-protection feature is cancel-
led and the seat backrest can be adjusted
again.
i
The seat backrest can be adjusted when the
key is removed from the ignition lock.
X
To adjust the seat backrest: press the
upper or lower section of switch
;
.
The seat backrest is lowered or raised.
You will hear the noise of the pump once the
seat backrest angle of approximately 45° is
exceeded. A pump automatically draws air
from the cushions, so that a level bed is cre-
ated.
If the power supply is disconnected during the
adjustment, the electronics of the seat/berth
combination will subsequently malfunction.
You then need to reset the seat/berth com-
bination (
Y
page 29).
X
To adjust the cushion contours: press the
upper or lower section of switch
:
.
The bases of the seat and the backrest are
inflated or deflated.
i
The maximum cushioning effect is achieved
once the noise of the pump stops.
26
Marco Polo seat/berth combination
Seats, berths and table
