A
Wedge
B
Pressure regulator (30 mbar)
C
Union nut
D
Main shutoff valve
E
Gas bottle
X
Turn main shutoff valve
D
of gas cylinder
E
clockwise.
X
Loosen union nut
C
by turning it clockwise
(left-hand thread) and remove pressure regu-
lator
B
from gas cylinder
E
.
X
Remove wedge
A
together with gas cylinder
E
.
X
To fit: remove the protective cap or transpor-
tation lock from the gas cylinder where appli-
cable and screw on the main shutoff valve
together with the safety valve.
X
Check the forced ventilation in the gas cylin-
der container floor.
The floor ventilation must not be closed.
X
Insert gas cylinder
E
into the gas cylinder
container as shown in the figure.
X
Secure gas cylinder
E
with wedge
A
in the
position shown in the illustration.
i
There is a recess for the wedge in the gas
cylinder container.
X
Place pressure regulator
B
onto main shutoff
valve
D
and tighten union nut
C
by turning it
anti-clockwise. Make sure that the bolt con-
nection on main shutoff valve
D
of the gas
cylinder is tight.
X
Align cap
?
of the gas cylinder container and
fit into place.
i
The recesses on the cover for the quick-
release fasteners have differing radii.
X
Push quick-release fasteners
=
down slightly
and turn about a
1
/
4
of a turn clockwise.
Cap
?
is closed.
X
Insert intermediate floor.
X
Close wardrobe
;
.
Information on the gas cooker and gas shutoff
valve can be found in the "Kitchen" chapter .
Electrical system
Voltage supply
Your vehicle has two voltage supply circuits:
R
12 V power supply — direct current
Power supply via the auxiliary battery or with
a 230 V mains connection via the battery
charger.
R
230 V power supply — alternating current
Power supply via the 230 V mains connection
from the national grid.
The starter battery and auxiliary battery are con-
nected. For this reason you can also charge the
starter battery via the battery charger.
i
Maximum charge current for charging the
starter battery: 4 A.
12 V power supply
General notes
The 12 V power supply is supplied with power by
the additional battery. The central control panel
display shows the
#
symbol.
If you have connected the 230 V power supply
and switched on the residual current circuit
breaker:
R
the additional battery is charged
R
the 12 V power supply is supplied by the bat-
tery charger (
Y
page 65)
Electrical system
61
Water, gas, electr., Marco Polo
Z