Mercedes-Benz G 550 2020, Operator'S Manual

Page: 410 / 530

#
Attach wheel wrench 3 to socket 2 and
tighten the hub cap clockwise.
Specified tightening torque: 20 lb-ft
(27 Nm).
Raising the vehicle when changing a wheel
Requirements:
R
There are no persons in the vehicle.
R
The vehicle has been prepared for a wheel
change (
/
page 406).
R
The hub caps have been removed
(
/
page 407).
Installing the jack
#
Assemble pump lever 1 .
#
Place pump lever 1 with the recess on low‐
ering screw 2 on the jack.
#
Turn pump lever 1 clockwise as far as it will
go.
Lowering screw 2 is closed.
3 Adapter
To raise the vehicle at the front: adapter 3
must be secured on the jack.
To raise the vehicle at the rear: remove
adapter 3 from the jack.
Important notes on using the jack:
R
Only use the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle.
R
The jack is only designed for raising and
holding the vehicle for a short time while a
wheel is being changed and not for mainte‐
nance work under the vehicle.
408 Wheels and tires