Mercedes-Benz 2010 GLK 350, Operator'S Manual

Page: 109 / 344

The current program mode appears in the
multifunction display.
:
Program mode indicator
You should only change the program mode
when the automatic transmission is in park
position
P.
Automatic program mode
S will not be stored.
When the engine is turned off with the
automatic program mode
S selected, the
automatic transmission will go to the
automatic program mode
C when the engine
is restarted.
X
Press the program mode selector switch
repeatedly until the letter of the desired
program mode appears in the multifunction
display.
Selecting program mode C means:
R
The vehicle starts out more gentle, both
forward and reverse, except when driving
off with full throttle.
R
Traction and driving stability are improved
on icy roads.
R
Upshifts occur earlier even when you give
more gas. The engine then operates at
lower revolutions and the wheels are less
likely to spin.
Selecting program mode S means that
upshifts occur later.
One-touch gearshifting
With the automatic transmission in drive
position
D, you can limit or extend the gear
range using the gear selector lever.
Limiting gear range
G
Warning!
On slippery road surfaces, never downshift in
order to obtain braking action. This could
result in drive wheel slip and reduced vehicle
control. Your vehicle’s ABS will not prevent
this type of loss of control.
X
Briefly press the gear selector lever to the
left in the
D- direction.
The automatic transmission will shift into
the next lower gear as permitted by the
shift program. This action simultaneously
limits the gear range of the automatic
transmission.
i To avoid overrevving the engine when
downshifting, the automatic transmission
will not shift into a lower gear if the engine’s
maximum speed would be exceeded.
Extending gear range
X
Briefly press the gear selector lever to the
right in the
D+ direction.
The automatic transmission will shift into
the next higher gear as permitted by the
shift program. This action simultaneously
extends the gear range of the automatic
transmission.
i If you press on the accelerator pedal
when the engine has reached the
revolution limit of the current gear range,
the automatic transmission will upshift
beyond any gear range limit selected.
Canceling gear range limit
X
Press and hold the gear selector lever to
the right in the
D+ direction until the gear
Automatic transmission
107
Controls in detail
X204_AKB; 3; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T19:16:58+02:00 - Seite 107
Z