Mercedes-Benz 2010 GLK 350, Operator'S Manual

Page: 52 / 344

X
Push latch plate
;
into buckle
=
until it
clicks.
X
If necessary, adjust the seat belt to the
correct height (
Y
page 50).
X
If necessary, tighten the lap portion to a
snug fit by pulling shoulder portion up.
All lap/shoulder belts except the driver’s seat
belt have special seat belt retractors to
secure child restraints properly. For more
information on special seat belt retractors,
see “Infant and child restraint systems”
(
Y
page 54).
To release the seat belt with seat belt release
button
?
, see (
Y
page 50).
Releasing the seat belts
X
Press seat belt release button
?
(
Y
page 49).
Allow the retractor to completely rewind
the seat belt by guiding latch plate
;
(
Y
page 49).
! Make sure the seat belt retracts
completely. Otherwise the seat belt and/or
latch plate could get caught or pinched in
the door or in the seat mechanism. This can
damage the seat belt and impair its
effectiveness, and/or cause damage to the
door and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limited Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
Rear center seat belt
The seat belt of the rear center seat may be
blocked when the left rear seat backrest is
folded forward and back (
Y
page 189). The
seat belt can then not be pulled out.
X
Unblocking the seat belt of the rear
center seat: Pull the center seat belt
approximately 1 in (25 mm) out of the seat
belt outlet in the seat backrest and release
it.
The seat belt is retracted and unblocked.
Seat belt outlet height adjustment
You can adjust the height of the seat belt
outlet for the driver’s and front passenger
seat.
X
Raising: Slide the seat belt outlet height
adjuster upward.
The seat belt outlet height adjuster
engages in different positions.
X
Lowering: Press and hold release
button
:
.
X
Slide the seat belt outlet height adjuster
downward.
X
Release release button
:
and make sure
the seat belt outlet height adjuster engages
into place.
Enhanced seat belt reminder system
When the engine is started, the seat belt
telltale
7
will always illuminate for
6 seconds to remind you and your passengers
to fasten your seat belts.
If the driver’s seat belt is not fastened when
the engine is started, an additional warning
chime will sound. The warning chime goes out
after approximately 6 seconds or once the
driver’s seat belt is fastened.
50
Occupant safety
Safety and security
X204_AKB; 3; 23, en-US
d2ureepe,
Version: 2.11.8.1
2009-07-16T19:16:58+02:00 - Seite 50