G
Risk of injury
Comply with the manufacturer's safety
instructions shown on the sticker on the elec-
tric air pump.
Your vehicle may be equipped with one of two
different air pumps. Version 1 can be identi-
fied by the flap, behind which the hose with
the pressure gauge and cable are located;
version 2 has a pressure gauge integrated in
the electric air pump.
Version 1
X
Open flap
;
on the electric air pump.
X
Pull connector
A
with cable and air pump
hose
B
out of the housing.
X
Screw air pump hose
B
onto flange
C
of
TIREFIT sealant filler bottle
:
.
X
Place TIREFIT sealant filler bottle
:
head
downwards into recess
=
of the electric
air pump.
X
Remove the cap from valve
E
on the faulty
tyre.
X
Make sure pressure release screw
F
on
pressure gauge
G
is fully closed.
X
Screw filler hose
D
onto valve
E
.
X
Insert connector
A
into the socket of the
cigarette lighter* (
Y
page 208) or into a
12 V power socket (
Y
page 209) in your
vehicle.
X
Vehicles without KEYLESS GO*: turn the
key to position 2 (
Y
page 75) in the ignition
lock.
X
Vehicles with KEYLESS GO*: press the
Start/Stop button twice (position
2 (
Y
page 75)).
X
Press on/off switch
?
on the electric air
pump to I.
The electric air pump is switched on. The
tyre is inflated.
i
First, TIREFIT is pumped into the tyre. The
pressure can briefly rise to around 5 bar.
Do not switch off the electric pump dur-
ing this phase.
X
Let the electric pump run for five minutes.
The tyre should then have a pressure of at
least 1.8 bar.
!
Do not operate the electric air pump for
longer than eight minutes at a time without
a break. It may otherwise overheat.
The air pump can be operated again once
it has cooled down.
Flat tyre
311
Practi
cal
advic
e
* optional
212_AKB; 2; 4, en-GB
mkalafa,
Version: 2.11.8.1
2009-05-05T14:17:16+02:00 - Seite 311
Z
Dateiname: 6515346702_buchblock.pdf; erzeugt am 07. May 2009 14:17:21; WK