2515 Bypass Rd. Flemingsburg, KY 41041
606-845-7439
Instructions for Installation and Care of Bobcat 3400 Polaris Ranger
Full Cab Enclosure Fits Lexan
BC-3400-FC05 (NEW STYLE)
Notice: Do not smoke inside the cab or expose the enclosure to direct flames. Cab is Flammable.
Be sure to read these instructions thoroughly before opening and installing the enclosure. The installation is
best done when the temperature is 70 degrees F. or warmer. The temperature affects the adhesive Velcro, if
conditions prevent installing in warmer weather it helps to store the adhesive Velcro at room temperature
prior to installation.
1.
Carefully open the carton and remove the enclosure on a large flat surface that is clean and free of dirt.
2.
Check over the parts included in the carton with the parts list shown below:
Adhesive Velcro Hook Strips:
Soft Doors
“ “ “ “
18 each------------3"
“ “ “ “
2 each------------38"
Snap Screw Studs
15 each ( 1 extra )
---------------------------------------------------------------------------
Adhesive Velcro Hook Strips:
Rear Window
“ “ “ “
8 each------------3"
“ “ “ “
1 each------------30"
“ “ “ “
1 each------------55"
---------------------------------------------------------------------------
Top Cap
31” Webbing Straps w/ Grommet
2 each
31” Webbing Straps w/Hook
2 each
45” Webbing Straps w/ Loop
2 each
Adhesive Velcro Hook Strips:
2 each------------6”
The cab for your Ranger is made up of 5 different components that work together to enclose your vehicle.
Install the cab in the following order.
1) Soft Doors
2) Rear Window
3) Poly Windshield
4) Top Cap
If any parts are damaged or missing please contact customer service at (606) 845-7439.
