i
The garage door opener is only available
for certain countries. Observe the legal
requirements in all countries concerned.
The HomeLink
®
garage door opener is
compatible with most European garage and
gate opener drives. More information on
HomeLink
®
and/or compatible products is
available from:
R
any Mercedes-Benz Service Centre
R
the HomeLink
®
hotline
(0) 08000 466 354 65 (free of charge) or
+49 (0) 6838 907-277 (charges apply)
R
the Internet: www.homelink.com
G
Risk of accident
Only press the transmitter button on the inte-
grated remote control if there are no persons
or objects present within the sweep of the
garage door. Persons could otherwise be
injured as the door moves.
Programming the remote control
i
You will achieve the best results by insert-
ing new batteries in the garage door's
remote control before programming it.
X
Erase the memory of the integrated remote
control (
Y
page 213) before programming
it for the first time.
X
Turn the key to position 2 in the ignition
lock.
X
Press and hold one of transmitter but-
tons
;
to
?
on the integrated remote
control.
Indicator lamp
:
starts to flash after a
short while. It flashes about once a second.
i
Indicator lamp
:
flashes immediately
the first time the transmitter button is pro-
grammed. If this transmitter button has
already been programmed, indicator
lamp
:
will only start flashing at a rate of
once a second after 20 seconds have
elapsed.
X
Keep the transmitter buttons depressed.
X
Point the garage door's remote control with
the transmitter towards the left-hand side
of the rear-view mirror from a distance of 5
to 20 cm.
i
The distance between the garage door's
remote control and the integrated garage
door opener depends on the system of the
garage door drive. You might require sev-
eral attempts. You should test every posi-
tion for at least 20 seconds before trying
another position.
X
Keep the transmitter button on the garage
door's remote control depressed until indi-
cator lamp
:
starts to flash rapidly.
The programming was successful if indica-
tor lamp
:
flashes rapidly.
X
Release the transmitter buttons on the
garage door's remote control and the inte-
grated remote control.
If indicator lamp
:
goes out after approx-
imately 20 seconds and did not flash rapidly
before this:
X
Release the transmitter buttons on the
integrated and portable remote controls.
X
Repeat the programming procedure. When
doing so, change the distance between the
garage door's remote control and the trans-
mitter buttons in the rear-view mirror.
i
If the garage door system works with a
rolling code, after programming you must
212
Features
Controls
212_AKB; 2; 4, en-GB
mkalafa,
Version: 2.11.8.1
2009-05-05T14:17:16+02:00 - Seite 212
Dateiname: 6515346702_buchblock.pdf; erzeugt am 07. May 2009 14:16:52; WK