Bulb holder
A
Reversing light
B
Turn signals
C
Rear foglamp
X
Brake and rear foglamps: press the rele-
vant bulb gently into the bulb holder, turn it
anti-clockwise and remove it from the bulb
holder.
X
Insert the new bulb into bulb holder and
turn it clockwise.
X
Turn signal: press the bulb gently into the
bulb holder, turn it anti-clockwise and
remove it from the bulb holder.
X
Insert the new bulb into bulb holder and
turn it clockwise.
X
Secure the bulb holder to attachment
=
on
the tail lamp and tighten nuts
?
.
X
Insert the tail lamp into the vehicle and
make sure that it sits correctly in guides
D
.
X
Tighten wing nut
:
and re-establish con-
tact with connector
;
.
X
Close the side trim panel (
Y
page 128).
Windscreen wipers
Switching the windscreen wipers on/
off
!
Do not operate the windscreen wipers
when the windscreen is dry, as this could
damage the wiper blades. Moreover, dust
that has collected on the windscreen can
scratch the glass if wiping takes place when
the windscreen is dry.
If it is necessary to switch on the wind-
screen wipers in dry weather conditions,
always operate them using washer fluid.
!
If the windscreen wipers leave smears on
the windscreen after the vehicle has been
washed in an automatic car wash, this may
be due to wax or other residue. Clean the
windscreen with washer fluid after an auto-
matic car wash.
Combination switch
1
$
Windscreen wipers off
2
Ä
Intermittent wipe, low (rain sensor
set to low sensitivity)
3
Å
Intermittent wipe, high (rain sensor
set to high sensitivity)
4
°
Continuous wipe, slow
5
¯
Continuous wipe, fast
B
í
Single wipe/
î
wipes the wind-
screen using washer fluid
X
Turn the key to position 1 or 2 in the ignition
lock (
Y
page 157).
X
Turn the combination switch to the corre-
sponding position.
Windscreen wipers
129
Lights
and
windsc
ree
n
wipers
Z
