Installation Steps
Step 1
1. After assembling the foot pad (86) and rear foot pipe(87)
2. Fixing the front foot pipe (85) with screws, and aligning hole sites from the lower foot pipe with two carriage screws
In the same way, Fixing the rear foot pipe(87) with screws, and aligning hole sites from the lower foot pine with
carriage screws(88) Screwing with an Allen wrench (99).
Step 2
1. Firstly, inserting the front pipe ornament cover (94 ) into the handlebar stand pipe(30), and then the connecting line (31)
is connected with the induction line (56) in the figure.
2. Firstly, turning the fine adjustment to the maximum value (level 8). Connecting the fine-tuning wire (32) of the
platform and fining the upper end (96). Inserting the handlebar stand pipe(30) into the platform (59).
STEP 2
32
94
31
30
96
32
56
96
59
STEP 1
88
85
87
86
59
8