Mendota SEABROOK D-30, Installation & Operating Instructions Manual

Page: 19 / 39

18
INSTALLATION CHECK OFF LIST
The following check list must be completed prior to initial lighting of the Fireplace
Insert, or manufacturer's warranty and liabilities will be voided:

Venting system must be installed by a Mendota approved person according to
Figure 3, Pg. 7 with clamps securely in place and all joints leak proof.

Electrical supply and gas supply must be properly installed and must conform to
National and Local Codes.

Check that correct fuel supply is connected to appliance. Check correct gas pres-
sure, correct size gas lines and for gas leaks.

Proper clearances to combustibles must be maintained.
LIGHTING CHECK OFF LIST
Be sure to check these items before final operation of the Fireplace Insert

All items on "Installation Check Off List" must be completed.

Connect Rocker Switch, Wall Switch, Remote Control or Thermostat to main valve.

Carefully follow all lighting and log installation instructions.

Take system millivolt readings [See Pg. 30]
Be sure pilot flame has a minimum of 450 millivolts.

Make certain that burner lights immediately and flame runs promptly around "curve" in
burner and lights entire burner. DO NOT proceed with operation unless burner cycles
"on/off" without delays and that the flame is "stable" and not "lifting" off burner.

Caution: If pilot goes out be sure to wait a minimum of 5 minutes before relighting.
Always light pilot with glass and logs removed.