Mendota E-FV44I ECHO SERIES, Installation & Operating Instructions Manual

Page: 29 / 48

Part #85-03-00855 28
BEFORE YOU BEGIN
Read this entire manual before you use your new fireplace insert(especially the section “Safety Precautions”). Failure to follow the
instructions may result in property damage, bodily injury, or even death.
Remote Control Transmitter Functions
NOTE : The Wall Receiver will “beep” once every time
a Remote Transmitter Key is pressed, signaling that
the command has been received.
Identify the four function buttons on the Remote
Transmitter:
1. ON/OFF KEY : This button turns the
system ON or OFF. When this but-
ton is pressed and the system is
OFF, the pilot light will stay ON if
the “Standing Pilot Switch” is in the ON position.
2. THERMOSTAT KEY : This button, when pressed after the ON/OFF KEY is pressed and the sys-
tem is ON, will allow the selection of three modes: Manual Operation, Normal Thermostat and
Smart Thermostat.
a. Manual Mode : In this mode, the room temperature is ignored and the fireplace can be turned ON indefinitely. The
room temperature rise has no effect on this mode. Other functions such flame height control will be manually
controllable.
b. Normal Thermostat : In this mode, the fireplace will
stay functioning until the room temperature increases
1
o
F above the Set Point Temperature. To increase the
Set Point Temperature, Press the UP button until the
desired temperature is displayed in the SET POINT
TEMPERATURE window. The flame height can be ad-
justed while the fireplace is functioning
c.
Smart Thermostat : In this mode, all other functions
except the flame height adjustment are allowed. Ma-
nual flame height adjustment is not allowed in this
mode. The Smart Thermostat function adjusts the
flame height in accordance to the difference between
the set point temperature and the actual room tempera-
ture. As the room temperature gets closer to the set
point temperature, the Smart Function automatically
modulates the flame down.
3. UP/DOWN KEY : This key is used to increase or decrease the Set Point Temperatures and Flame
Height.
4. MODE SELECTION KEY : This key is used to toggle between the various function icons: Set Temperature and Flame
Height/Gas Input Rate.
SMART
ON
OFF
SMART
MODE
NORMAL
THERMOSTAT
MANUAL
MODE
68 Hi
MAX MAX
Hi
OFF
76°
F F
76°
ON SMART
76°
F