12
For Build 050109 and later
DS1 with RJ-45 Cable Diagrams
The DS1 ports normally require a cross-over cable between it and the CPE
(Customer Premise Equipment.) These cables can be made with a standard
CAT5 Ethernet cable using the pin out drawings below.
You can use a loop back plug in the Flanger4Plus remote unit to do bench
testing.
DS1 Crossover Cable
DS1 Loop-Back Plug
CAT5 Ethernet Cable Diagrams
Used by cable from your provider power supply into Local port and out of
WAN port.
Note
: Although the Flanger4Plus unit supports reversed polarity on its
power leads, other equipment powered by the Flanger4Plus may not.
Note
: The Ethernet cable should be limited to a maximum of 100
meters or approx. 328 feet.
Pinout with Power over CAT5
Pinout without Power over CAT5
