Member's Mark G70201, Assembly Instructions & User Manual

Page: 12 / 44

1-833-454-0864
1 2
PREVENTION
ATTENTION
Once lit, confirm that the burner is properly lit and that the flame pattern is as desired. If the flame pattern is other
than normal, consult the troubleshooting guide for corrective action.
Burner Flame Check
The burner flame pattern is the key indicator of proper or improper
function within the firebox. When the burners are performing correctly,
you will see a specific flame pattern. All burner ports should be
2.5cm/1” flame on
“MAX”
with orange tips, light blue center, with dark
blue flame at the base of the burner port (See image C). Refer to the
troubleshooting steps.
Light the burners and rotate the knobs from
“MAX”
to
“MIN”
. You
should see a smaller flame in low position than seen on high. Perform
burner flame check by looking below the griddle top on the side of the
unit to view the burners below. Always check the flame before each
use. If there is a sudden drop or low flame issue, please refer to the
troubleshooting section.
Flash-Back Fires
A flash-back fire occurs when a blockage in the venturi tubes caused by spiders, insects, and nests block the flow of
gas, forcing it back towards the control panel and control knob. The ignited gas, if not detected, can cause a fire to
burn in this area.
If you experience any of the characteristics of a flash-back fire, close the LP cylinder shut-off
immediately. Follow the burner cleaning procedure outlined in the maintenance section of this manual.
MAX
MIN
C