Member's Mark G70201, Assembly Instructions & User Manual

Page: 7 / 44

1-833-454-0864
7
CAUTION
It is important to inspect the cylinder connection device. Check the propane tank valve rubber seal for cracks,
wear or deterioration prior to use. A damaged rubber seal can cause a gas leak, possibly resulting in an explosion,
fire, or severe bodily harm. Do not use a propane tank with a damaged rubber seal.
DANGER
•
NEVER
store a spare LP cylinder under or near the appliance, or in an enclosed area.
•
DO NOT
store an LP tank in an area where children play.
•
LP cylinder should only be stored outside and in a cool dry place.
•
NEVER
expose the cylinder to direct sunlight or excessive heat.
•
If you see, smell or hear gas escaping, immediately get away from the LP cylinder/appliance and call your fire
department.
WARNING
If the information above is not completely adhered to, a fire/explosion causing death or serious injury may occur.
Any attempt to connect a regulator to any connections other than the included connector could result in fires,
explosions, injuries, or property damage. Use only LP cylinders equipped with this type of valve.
LP CYLINDER FILLING
SAFETY HOSE AND REGULATOR
•
Use only licensed and experienced dealers.
•
Ensure that the dealer checks and tests the tank for leaks after filling.
•
LP dealer must purge new cylinder before filling.
•
Dealer should NEVER fill LP cylinder more than 80% of LP cylinder volume. Volume of propane in cylinder will
vary by temperature.
•
Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice.
•
To remove gas from LP cylinder, contact an LP dealer or call a local fire department
for assistance.
Your griddle is designed to operate on LP gas at a pressure of 2.74Kpa (11” water column). A regulator pre-set to this
pressure is supplied with your Griddle.
SAFETY FEATURES
of QCC-1 Quick Closing Coupling.
All models are designed to be used with an LP gas cylinder equipped with the
new QCC-1 Quick Closing Coupling system.
The QCC-1 System Incorporates
SAFETY FEATURES
required by the
Canadian Standards Steering Committee.
1. Gas will not flow until a positive connection has been made.
2. A thermal element will shut off the flow of gas between 240 degrees F and
300 degrees F. This may result in a melted regulator hose.
3. When activated, a Flow Limiting Device will limit the flow of gas to 10 cubic
feet per hour.
Nipple has to be centered
into the LP cylinder valve.
Regulator
Heat sensitive hand wheel
Nipple with flow limiting device