T. 1300 222 445 | www.melec.com.au
For further information about our Warranties please go to:
melec.com.au/legal/warranties
INSTALLATION WITH LUMINAIRE
1. Open the back of the light fitting to access the internal components. (A)
2. Safely locate the line and neutral wires of the fitting and connect the ML-ZIG-010-D
in line the of feed (refer to wiring diagram
“
Wiring Diagram when 0/1-10V Output
Selected”
).
3.
Safely locate the purple (+) and grey or pink (-) 1-10V dimming cables. Connect to
your 1-10V dimming system.
4. Use suitable fixing methods to fix the ML-ZIG-010-D onto the fitting (e.g. by screwing
the controller down onto the fitting, or using adhesive on bottom surface). (B)
5. Ensure you use suitable sealant/glands to keep the IP rating.
6. Refit the back plate and ensure all seals are secure. Water penetration from a failure
to seal the fitting properly will not be covered under warranty.
ML-ZIG-010D
FIX WITH SCREWS
A
B
C
Version 8