Weekly program (Cont’)
Programming procedure
The detailed programming procedure is described in the next sections. Make sure to follow the right
programming procedure, suitable for the program type and features selected by technician settings.
Press the [C/F-Prog] button to enter and proceed through the steps of the real time clock and
programming procedure.
Use the [+] and [-] buttons to select or change value of a flashing icon.
It is recommended to select programming values prior to the actual programming.
Exit the programming procedure
At anytime during the programming procedure, Press the [On/Off] button to exit and return to normal
display - any changed values will be saved.
Adjusting the time and day of the week
Press and hold the [C/F - Prog] button - the word “Clock” will appear on display.
Hours
The HOURS will flash.
Use the [+] and [-] buttons to adjust the hours.
Minutes
Press the [C/F - Prog] button again – the MINUTES will flash.
Use the [+] and [-] buttons to adjust the hours.
Days
Press the [C/F - Prog] button again – the DAYS will flash.
Use the [+] and [-] buttons to select the day.
If technician parameter P107 is not set to “00” (program is enabled), Press the [C/F – Prog] button
to enter programming procedure.
Make sure to follow the right programming procedure, suitable for the program type and features
selected by technician settings.
Section C – “EU Type”
Section D – “US Type”
Otherwise, press the [C/F - Prog] button to return to normal display.
- 10 -
