MEI CASHFLOW SC83 Page-14
www.meigroup.com Part # 252055088 G3
UPDATING SOFTWARE
There are two ways of updating the software of a Cashflow SC83 note acceptor.*
1) Via a hand held device called the Cashflow
Programming Module (CPM).
2) By replacing the programmed PROM (Chip Change).*
Cashflow Programming Module
C
onnecting the CPM to the CASHFLOW SC83
1. Locate the two USB ports located on the top of the Cashflow
Programming Module (See fig. 1 below).
2. Plug the type A end of your USB harness to the USB type A
port of the
CPM
. Plug the type B end of the same USB harness
into the USB type B port of the
Cashflow SC83.
(see fig.2).
fig.2
download button
fig.1 (CPM)
Type A USB port Type B USB port
*Note: Once a PROM (chip) is installed, the note acceptor can no longer be programmed via the programming
module (CPM). Installation of a PROM will disable the ability of the programing module (CPM) to communicate with
the note acceptor. Future software changes can only be made by replacing the PROM (chip change).