MEI CASHFLOW SC83 Page-11
www.meigroup.com Part # 252055088 G3
Eight pin harness connector
Installing an Entry Guide
• To install an entry guide, just slide it onto the acceptor module until it locks into place.
No screws are required. If the entry guide has lights, you will have to first connect the harness
from the entry guide to the eight pin connector located on the left hand side of the face of the
acceptor module.
• Make sure that the entry guide is aligned so the machine door closes properly.
Acceptor Module
entry guide
INSTALLATION
• Once the entry guide is aligned properly, remember to go back and tighten the screws on the
chassis (refer back to chassis installation instructions).
• To remove an entry guide, slide a flat head screwdriver
between the entry guide and the acceptor module.
(as shown in the diagram on the right)
