![background image](http://html1.mh-extra.com/html/megasat/traveller-man-3/traveller-man-3_user-manual_1765110028.webp)
2. Installation
06
ENGLISH
2.
Check that all parts are present.
3. Place the mounting plate on the later
mounting location. Ensure that the moun-
ting surface is level and that no roof structures are in the way. It is essential
to observe the mounting dimensions in these instructions. The minimum
distance to an air conditioner should be 30 cm.
4.
Clean the mounting surface with a suitable cleaner and a fleece cloth to
remove dirt and impurities. Then mark the base plate of the antenna with
a pen.
5.
Slightly roughen the drawn surfaces and feet with sandpaper (120 grain)
and clean the surface again with the cleaner and allow the cleaner to flash
off for about 10 minutes.
WARNING:
Do not touch the surfaces afterwards.
6. Mount the roof lead-through (preferably in the slipstream behind the an-
tenna) on the vehicle roof. Make sure that the penetration of water and
moisture (e.g. rain or splash water) into the drill hole is avoided. Make sure
that the cables are not bent too much to avoid signal loss and damage to
the cable (smallest bending radius max. 5-7 cm).
2.2 Installation on the roof
1.
Make sure that the roof of your vehicle is sufficiently stable. If the roof sta
-
bility is insufficient or doubtful, attach an approx. 2 mm thick sheet metal
plate measuring approx. 100 x 100 cm to the outer skin of the roof. Please
ask your vehicle manufacturer for more information.
Important:
The antenna must point with the motor unit in driving direction!
Direction of travel
Summary of Contents for Traveller-Man 3
