Megamaster 200 Fusion, Assembly & Operating Instructions

Page: 26 / 36

25
GRILL & LIGHTING INSTRUCTIONS
WARNING: IMPORTANT BEFORE LIGHTING!
Inspect the gas supply hose prior to turning the gas “ON”. If there is evidence of cuts, wear, or
abrasion, it must be replaced prior to use. Do not use the grill if the odor of gas is present. Do not use
any other hose connection other than the regulator hose assembly that came with the unit.
Never substitute regulators and hose assembly for those supplied with the grill. If a replacement is
necessary, contact the manufacturer for proper replacement. The replacement must be specified in
the owners manual.
WARNING: Always keep your face and body as far away from the burner as possible when lighting.
TO LIGHT THE MAIN BURNER
Make sure all knobs are “OFF” then turn on the gas supply from the LP gas cylinder. Always keep your
face and body as far from the grill as possible when lighting.
Your grill has an exclusive patented built-in ignition. The igniter is battery operated. To ignite each
burner simply push and turn the control knobs to the HI setting, you will hear gas flow through. Press
and hold the Ignitor button until burner ignites.
FLAME CHARACTERISTICS
Check for proper burner flame characteristics.
Burner flames should be blue and stable with no yellow tips, excessive noise, or lifting. If any of these
conditions exist call our customer service line. If the flame is yellow, this is a indication of insufficient
air. If the flame is noisy and tends to lift away from the burner, this is a indication of excessive oxygen.
Visually check the burner flames prior to each use; the flames should /- 1 inch tall (2.5cm).
If they do not, refer to the burner maintenance part of this manual.
Each burner is adjusted prior to shipment; however, variations in the local gas supply may make
minor adjustments necessary.
LOW LOW LOW LOW
IGNITE
/ HIGH
OFF OFF OFF OFF
IGNITE
/ HIGH
IGNITE
/ HIGH
IGNITE
/ HIGH
Main Burners
LOW
4
ELECTRONIC
IGNITION BUTTON
2
3
1
OFF
IGNITE
/ HIGH
Side Burners
1.
2.
3.
4.
5.
Note: Remove all packaging, including straps, before using the grill
Open lid during lighting.
Make sure all the knobs are in the “OFF” position,
and then turn the Liquid Propane Cylinder valve
“ON” by slowly turning counterclockwise.
Push and turn Main Burner control knob to
IGNITE/HIGH, at the same time, press and hold
electronic ignition button to light the burner.
Once the burner is lit, release the electronic ignition
button and knob.
If ignition does not occur in 5 seconds, turn the
knob to OFF, wait 5 minutes and repeat the lighting
procedure or light by match.
LIGHTING INSTRUCTIONS