EN
54
Depth stop
The depth stop is intended to ensure that the desired
cutting depth is obtained.
1.
Turn the depth stop (3) outward.
2.
Loosen the lock nut (2), turn the depth stop
screw (1) upward or downward depending
on the desired cutting depth.
3.
Lower the blade carefully to check the
cutting depth.
4.
Tighten the lock nut
Measures after sawing
1.
Lower the saw head
2.
Release the trigger and wait until all parts of the tool come to a complete stop
3.
If the saw blade does not stop within 8 seconds, unplug the tool from the power outlet and
leave the tool at an authorised service centre for repair.
4.
Do not leave the tool unattended when working. Stop the tool and secure it against
accidental start up if you have to leave the workplace.
MAINTENANCE
WARNING:
• Always disconnect the plug from the power outlet before starting any maintenance.
• Never apply oil on the rotating saw blade.
• Do not use solvents to clean.
• If the cord is damaged, the tool must be switched off immediately and unplugged from the
power outlet. The damaged cord must be replaced at an authorised service centre or by another
qualified person.
Replacing carbon brushes
The carbon brushes normally need to be replaced after every 50 operating hours or after every
10,000th sawing operation (on/off cycle). Both carbon brushes must be replaced together when one
of them is worn to about 6 mm length.
1.
Unplug the tool from the power outlet, before starting to replace the carbon brushes.
2.
Remove the black cover on the motor cover and pull out the carbon brush.
3.
Insert the new carbon brushes and refit the cover.
NOTE:
Replacement brushes must be of the same type as the replaced brushes.
