EN
32
• Lay out the power cord so that it cannot
be damaged by rotating parts.
Otherwise the power cord can be
damaged, or fasten and pull your hands
or arms towards the accessory.
• Switch off the product and wait until all
moving parts have completely stopped
before putting it down. Otherwise the
accessory can catch on the surface and
cause the product to move out of control,
which can result in serious personal injury.
• Do not start the product when carrying it
at your side. Rotating parts can fasten in
your clothing and cause serious personal
injury.
• Clean the ventilation openings on the
product at regular intervals. The tool can
overheat otherwise.
• Do not use power tools in explosive
environments, such as in the vicinity of
flammable liquids, gas or dust.
Power tools produce sparks that can
ignite dust and fumes.
• Do not use accessories that require
coolant. Water and coolant increase
the risk of electric shock.
WARNING FOR KICK-BACK
• Hold the product firmly with both hands
and hold your arms in a position that
prevents kickback. Support handles should
always be used to keep the tool under
control. Kickback can cause the product to
jerk backwards, but the user can control
this by taking the appropriate measures.
• Never put your hands near moving parts.
Kickback can cause the accessory to pass
over your hands.
• Do not stand with any part of your body in
line with the kickback trajectory.
The kickback trajectory runs in the
opposite direction to the movement of
the accessory at the point of engagement.
• Be careful on curves, corners and edges
etc. and do not allow the accessory to
bounce against the workpiece. There is
rated speed can shatter and cause
personal injury.
• Never use accessories with an external
diameter or thickness larger than what
the product is intended for. Using
accessories of the incorrect size will make
the product difficult to handle and cause
the safety devices to malfunction.
• Only use accessories with the correct size
and shape of centre hole to fit on the
product. An incorrect size and shape of
centre hole will result in imbalance in the
product and excessive vibration, and can
make the product difficult to use.
• Do not use damaged accessories.
Always check before use that discs and
other accessories are not cracked or
otherwise damaged. Do not use products
or accessories that are damaged, or not
working properly. When the accessory has
been checked and fitted, hold the product
at a safe angle and run it at maximum
speed for 1 minute. If the accessory is
damaged it will probably break during
this test.
• Use personal safety equipment. Wear
approved safety glasses or a visor,
depending on the application. Use
supplementary protective equipment, such
as dust filter mask, ear protection, gloves
and an apron if necessary. Use eye and face
protection to stop chips and other particles
that can be ejected when working. A dust
filter mask filters dust and particles produced
when working. Prolonged exposure to loud
noise can cause hearing impairment.
• Keep onlookers at a safe distance from the
work area. Everyone in the work area
must wear personal safety equipment.
Fragments of workpieces or defective
accessories can result in personal injury.
• Hold the product by the insulated grips
when working in areas where it could
come into contact with concealed
electrical cables or its own power cord.
Contact with a live cable will cause the
metal parts on the product to also
become live – risk of electric shock.
Summary of Contents for 014138
Page 4: ...1 1 1 2 3 4 5 6 7 8 9 10 11 3 8 11 ...
Page 5: ...3 4 4 ...
