ASP-I-MASPI-9 MedRx AVANT REMsp Installation Manual
Effective Date: 10-21-2016
11
EMC Precautions
The Avant REMsp needs special precautions regarding EMC and needs to be installed
and put into service according to the following EMC information.
List of all cables and maximum lengths of cables, transducers and accessories:
Transducer / Accessories
Maximum Cable length
USB Cable
2,9 meters
All Speakers
2,9 meters
Warnings!
•
The use of accessories and cables other than those specified, with the exception of
transducers and cables sold by the manufacturer of the Avant REMsp as replacement
parts for internal components, may result in increased emissions or decreased immunity
of the Avant REMsp.
•
The Avant REMsp should not be used adjacent to or stacked with other equipment and if
adjacent or stacked use is necessary, the Avant REMsp should be observed to verify
normal operation in the configuration in which it will be used.
•
The Avant REMsp may be interfered with by other equipment, even if that other
equipment complies with CISPR emission requirements.
•
The Avant REMsp does not have life supporting function
•
Portable and mobile RF communications equipment can affect the Avant REMsp.
Guidance and manufacturer’s declaration – electromagnetic emissions
The Avant REMsp is intended for use in electromagnetic environment specific below. The customer or the user of the
Avant REMsp should assure that it is used in such an environment.
Emission test
Compliance
Electromagnetic environment - guidance
RF emissions
CISPR 11
Group 1
The Avant REMsp uses RF energy only for its
internal function. Therefore, its RF emissions are
very low and are not likely to cause any
interference in nearby electronic equipment.
RF emissions
CISPR 11
Class B
The Avant REMsp is suitable for use in all
establishments, including domestic
establishments and those directly connected to
the public low - voltage power supply network
that supplies buildings used for domestic
purposes.
Harmonic emissions
IEC 61000-3-2
Non applicable
Voltage fluctuations / flicker emissions
IEC 61000-3-3
Non applicable
Guidance and manufacturer’s declaration – electromagnetic immunity
The Avant REMsp is intended for use in electromagnetic environment specific below. The customer or the user of the
Avant REMsp should assure that it is used in such an environment.
Immunity test
IEC 60601 test level
Compliance level
Electromagnetic
environment - guidance
Electrostatic discharge
(ESD)
IEC 61000-4-2
+/- 6 kV contact
+/- 8 kV air
+/- 6 kV contact
+/- 8 kV air
Floors should be wood,
concrete or ceramic tile. If
floors are covered with
synthetic material, the
relative humidity should be
at least 30%.
