M
M
A
AIIN
N
C
C
O
OM
MP
PO
ON
NE
EN
NT
TS
S
51
I
NSTALLING A
PC
CARD
Follow the PC card installation instructions that are given for
use under Windows
®
and have the necessary driver software
ready. Once you have started Windows
®
, slip the card carefully
into the slot provided.
Â
Remove the dummy card from the PCMCIA Slot
before installation. Replace the card to protect
contacts against dirt if the Slot is not used.
When the card is fully inserted two audible signals will be
heard, provided it has been correctly recognized and success-
fully configured.
If only one signal is heard, this signifies a problem with the card
recognition. In this case, follow the instructions that accompany
your new PC card.
R
EMOVING A
PC
CARD
To remove your PC card:
1.
Press the eject button next to the slot.
Â
Attention!
The Eject Button should be
pressed
in
during transportation, because the danger will
arise that the button will break off otherwise.
Eject Button
Note: The location of
the PC Card slot may
vary. Refer to Side
Views on page 15.
Summary of Contents for Akoya XL
