After Sales Support
Telephone: 1300 884 987
Internet: www.medion.com.au
6
Place and operate all components on a
stable, level
and
vibration-free base
, in order to avoid the
monitor falling.
Adjust the monitor position and settings to avoid eye strain and guarantee comfortable operating
ergonomics. Position the monitor to avoid glare and reflections from sunlight or other light
sources. Adjust the brightness and contrast to suit the operating environment.
Take
regular breaks
when working at your monitor, to prevent tension and tiredness.
Repair
Leave the repair of your monitor exclusively to qualified specialist personnel.
Please contact our Help Desk on 1300 884 987 if you have any problems with your monitor.
Caution! Pay Attention To The Surrounding Temperature!
The monitor can be operated at a surrounding temperature from 0° C to +35° C and at a relative
ambient moisture level of < 80% (non-condensing).
The monitor can be stored at -20° C to +60° C when it has been turned off.
Danger! Pay attention to the following:
Wait to bring the device into operation until it has reached the surrounding
temperature, after the monitor has been transported.
Moisture, which can cause an
electrical short-circuit
, can form within the monitor
in the case of wide
variations in
temperature or moisture
.
Warning! Pay Attention To Safety During The Connection!
Power Supply
Please pay attention:
Parts of the device will be subject to voltage, even if the mains
switch has been switched off.
Pull the mains plug from the socket
, to interrupt the power
supply to your monitor or to release the device from voltage completely.
Only operate the monitor at an earthed socket with
100-240V~, 50/60 Hz.
Ask your energy
supplier if you are not sure about the power supply at the set-up location.
We recommend the use of
a surge protector against excess voltage
for additional safety, in
order to protect your monitor against damage because of
voltage peaks
or
electrical
flashes
on
the mains network.
Pull the mains plug from the socket, in order to
interrupt
the
power supply
to your monitor.
Do not cover the power supply, in order to avoid damage because of undue heating.
Do not use the power supply any longer if the casing or the supply line to the device is damaged.
Replace it with a power supply of the same type.
Use the power pack supplied with the device exclusively (Model: FSP 036-RHC).
The
socket
must be located close to the monitor and be
easily accessible
.
Lay the cable so that no-one can tread on it or trip over it.
Do not place
any objects on the
cable, because it could be damaged otherwise.
Please pay attention to the fact that the standby switch does not separate the device completely
from mains electricity. The device will consume electricity in standby operation apart from this.
Pull the mains plug out of the mains socket to separate the device from the network completely.
Maintain at least one metre clearance from
high frequency
and
magnetic sources of interference
(television device, loudspeakers, mobile phone, cell phone, etc.), in order to avoid disruptions to
function and data loss.
