Medias Mediatrix 1204, Reference Manual

Page: 51 / 390

Mediatrix 1204 25
C
H A P T E R
2
Web Interface – Introduction
The Mediatrix 1204 contains an embedded web server to set parameters by using the HTTP protocol.
Introduction
The web interface may be used to:
View the status of the Mediatrix 1204.
Set numerous parameters of the Mediatrix 1204.
All parameters located in the web interface may also be configured via SNMP. Each section of the
web interface suggests a link to the corresponding SNMP section.
Before using the web-based configuration service, you must ensure that it is enabled.
X
To enable the web-based configuration service:
1. In the ipAddressConfig folder, set the TCP port on which to listen for HTTP requests in the
httpServerPort variable (under the ipAddressConfigHttpEngine group).
2. In the httpServerMIB , enable the service by setting the httpServerEnable variable to enable .
Using the Web Interface
Mediatrix recommends that you use the latest version of the Microsoft
®
Internet Explorer web browser to
properly access the web interface.
X
To use the web interface configuration:
1. In your web browser’s address field, type the IP address of the Mediatrix 1204 (if you have
performed a recovery mode, this is
192.168.0.1 ).
The following opens:
Figure 9: Login Window
The Mediatrix 1204 uses Digest Authentication to grant access to web-based interface.
Standards Supported RFC 2616 – Hypertext Transfer protocol - HTTP/1.1.