Medialon Showmaster Go, Hardware Manual

Page: 27 / 80

Showmaster Overview
Medialon Control System p 25 of 80
User Reference Manual
M515-2 | 2020-May
o
Starting Up : Showmaster Pro is starting up (from power-on until Showmaster Pro is
ready)
o
Running : Showmaster is running and no Showmaster Editors are connected. Medialon
Showmaster also goes to this state when no show file is loaded.
o
Programming : A Showmaster Editor V2 is connected to Showmaster and a project is
being edited or tested
o
Run Fault : the project has caused a runtime error, typically a zero-division error
o
Recovery : The Showmaster has been started in Recovery mode
o
Upd Firmware : Showmaster V2’s firmware is being updated
o
Downloading : A Showmaster V2 project is being downloaded from an Editor
o
Uploading : The current Showmaster V2 project is being uploaded to an Editor
o
Factory : Showmaster is being reset to its factory default state
o
Shutdown : Showmaster is shutting down
o
Reboot : Showmaster is rebooting
3. [Vers] Showmaster’s current firmware version
4. [Proj] Title of the running project (This line is not available when Showmaster is in recovery
mode)
5. [Test] When Showmaster is in Recovery Mode, this line indicates the status (On/Off) of the
test session
6. [Addr] Current IP address
7. [Mask] Subnet mask
8. [Gway] IP Gateway address
9. [MacA] MAC address
10. [SerN] Serial Number
The lines below are displayed when Showmaster is in Recovery mode:
11. [Ser1] Serial port 1 status (Opened/Closed/Failure)
12. [Ser2] Serial port 2 status (Opened/Closed/Failure)
13. [Ser3] Serial port 3 status (Opened/Closed/Failure)