Unscrew the top plate handle so that the peg holders move
towards the outside edge of the plate. Align the top plate
with the torque drive so that the handle is on the left-hand
side of the top plate. Using the 2.5mm Allen key (provided),
tighten the four socket countersunk screws hand tight.
Assembly of the
Orbis
When the Orbis is in transit,
the top plate is removed to
avoid damage to the torque
sensor.
Fitting Instructions for the
Orbis Top Plate
Step 1. Orbis with torque
drive shown
Step 2. Align top plate
with torque drive.
The handle is
positioned to the
left.
Step 3. Tighten screws
hand-tight only.
Step 4. For use of Orbis
with handle at
front, repeat steps
1 to 3 but position
top plate
accordingly during
step 2.
page 3