33kHz General Purpose Sonde
The General Purpose Sonde is powered by a single standard alkaline
or Nickel-Metal Hydride rechargeable (NiMH) AA (LR6) size battery.
1. To turn the Sonde on, separate the two halves of the Sonde casing.
Insert a new battery into the battery compartment with the positive end down.
2. Screw the two halves of the Sonde together being careful not to over tighten
them. The Sonde is now transmitting a signal.
3. To turn the Sonde off the battery must be removed or reversed.
Non-Metallic Pipe Tracing using a Sonde:
Batteries
29
NOTE Only use an alkaline or Nickel-Metal Hydride rechargeable (NiMH) AA (LR6) size battery.
NOTE Dispose of the used battery safely in accordance with local regulations.
NOTE Always use a new battery in a Sonde if you expect to take a long time to trace the pipe or duct route.
WARNING The Locator must always be set to Generator Mode when using the Sonde.
+
-----
