15
Using the Signal Generator:
Batteries
C.Scope Signal Generators can be powered by either four standard alkaline
or by four standard Nickel-Metal Hydride rechargeable (NiMH) D (LR20) size batteries.
Signal Generator Battery Check
Switch the SGA3 Signal Generator on by pressing the On/Off Control.
The Signal Generator should emit a loud continuous tone.
If the batteries need replacing or recharging an interrupted tone will be heard.
During use, the Signal Generator will also warn the Locator user of low battery status
by altering its normal continuous or pulsed signal output to a distinct interrupted signal output.
Changing the Batteries
l
Remove the Accessory Tray.
l
Undo the two round knurled retaining screws situated on the underside of the Signal Generator holding the Battery Cover.
l
Remove ALL FOUR used batteries and replace with new ones.
l
Be careful to insert the new batteries the correct way round in the compartment as indicated on the case.
l
Replace the Battery Cover being careful to not over tighten the retaining screws.
l
Replace the Accessory Tray.
WARNING Do not change batteries in confined spaces where gas may be present.
WARNING Do not mix old and new or different types of batteries.
NOTE Only use alkaline or Nickel-Metal Hydride rechargeable (NiMH) D (LR20 ) size batteries.
NOTE Dispose of the used batteries safely in accordance with local regulations.
