PELLET STOVES
Chapter 4
INSTALLATION AND USE MANUAL
page
29
Operation
Technical service - Rights reserved MCZ GROUP S.p.A. - Reproduction prohibited
B
A
B
4.5.
SETTINGS TO CARRY OUT BEFORE FIRST
LIGHTING
Once the power cord is connected to the rear part of the stove, place
the switch, also on the rear, to position
(I).
The lighted button of the switch will come on.
The switch located to the rear of the stove powers the system.
The stove is off and on the panel the first screen appears with the word
OFF;
by pressing any key the screen with the word
MENU
will appear.
4.6.
FIRST LIGHTING
4.6.1.
ON/OFF from the control panel or remote
control (if purchased)
To switch the stove on and off, press the key
B for
2 seconds on the
control panel or the
A button
on the remote control (if purchased).
During the start-up phase lasting about 15 minutes:
Pellet loading is independent of the set power
The room temperature fan only starts when
temperature is reached
Once this phase ends the stove automatically enters in power
supply mode.
4.6.2.
Note on first ignition
The first attempt at ignition may not be successful,
since the feeder screw is empty and it is not always
able to fill the grate with required amount of pellets
in time to ensure normal ignition
Also the subsequent lightings that follow after the
pellets are depleted could fail, see par. 5.4.8.
“Loading the hopper”
CANCEL THE ALARM CONDITION FROM THE
CONTROL PANEL (see paragraph 6.1). REMOVE
PELLETS IN THE GRATE AND REPEAT LIGHTING
Summary of Contents for KAIKA
Page 1: ...USE AND MAINTENANCE MANUAL...
