34
OMM 1008-1
Figure 11, Detail View Screen
Data for one compressor is shown at a time on this screen. Pressing the COMPRESSOR button in the screen
lower-left hand corner will toggle between #1 and #2 compressor.
Pressing the VIEW button on the bottom of the Home View screen accesses the Detail View Screen shown
above. This screen gives additional information on the refrigerant pressures and temperatures.
Pressing the STATE button will bring up a display of the compressor state as described on page 35.
Pressing the I/O button displays the status of the compressor inputs and outputs as described in Figure 14 on
the same page. Magnitude units will have a COMP button that will toggle between the two compressors'
data, allowing the STATE and I/O detail screens to be viewed for either compressor.
Pressing the UNIT I/O button displays the unit inputs and outputs as described in Figure 15 on page 36.
Pressing the EVAP or COND button will give detailed information on the evaporator or condenser pressures
and temperatures.
Pressing the ACTIVE LWT SETPOINT button will show a window from which the leaving water setpoints
can be changed. However, it is recommended that the SETPOINT screens described later be used for this
purpose.
Pressing the MENU button on the bottom of the screen will go to a menu (see Figure 12) from which the
above listed screens can also be accessed.
This screen will be superimposed on the right side of the VIEW screen. This screen will remain
visible until another display button (such as STATE, I/O, etc.) is pressed.
