McLaren SUPER SERIES, Owner'S Handbook Manual

Page: 50 / 268

Before You Drive
Washers and Wipers
1.40
2. For a fast single wipe, push and hold
the wiper stalk down. The windscreen
wipers will perform a continuous fast
wipe until the stalk is released.
Windscreen wash/wipe
Pull the wiper stalk towards you.
The windscreen washers and wipers will
initially operate at a slow speed while the
stalk is held. If the stalk is held for more than
2 seconds, the wiper will operate at high
speed.
When the stalk is released, the wipers will
complete their cycle and return to the
parked position. After a period of time the
wipers will operate once more to wipe any
remaining washer fluid from the windscreen.
NOTE: The position of the washer jets
are set during vehicle manufacture
and should not need adjusting. If a
problem occurs, consult your McLaren
retailer.
Wiper park positions
In addition to the normal park position, there
are two alternative positions.
Ensure the vehicle is in Locked, Sleep or
Awake mode.
Pull the wiper control stalk towards you, the
wipers will move through the following park
positions each time the stalk is pulled:
Winter park
The wipers are parked vertically to reduce
the risk of damage to the wiper arms during
periods of heavy snowfall and provide access
for easier cleaning of accumulated snow.
Service park
The wipers are parked diagonally to provide
access for replacing the wiper blades, see
Replacing the wiper blades, page 6.28.
Normal park
The wipers are parked horizontally along the
lower edge of the windscreen.
p14.book Page 40 Tuesday, October 24, 2017 11:15 AM