McLaren SUPER SERIES, Owner'S Handbook Manual

Page: 211 / 268

Maintaining Your McLaren
Fuses
6.17
2. Release the two lower clips securing
the panel to the bulkhead and remove
the panel
3. Refer to the fuse specification to
determine which fuse protects the
non-functioning electrical system, see
Main fuse box fuse specification chart,
page 6.17.
NOTE: A label identifying the fuses is
attached to the inside of the access
panel.
4. Remove the appropriate fuse and
replace it with a fuse of the same value
as the original. If in doubt, check the
fuse specification chart.
5. Fit the access panel by inserting the
two upper retaining clips in the
bulkhead and securing with the two
lower clips.
NOTE: If a replacement fuse does not
solve the electrical problem, or it fails
immediately, contact your McLaren
retailer.
Main fuse box fuse specification chart
No. Amps Circuit protected
F1 60 Right-Hand Secondary Air
Pump
F2 60 Left-Hand Secondary Air
Pump
F3 - -
F4 - -
F5 30 Transmission Control Unit
F6 30 Transmission Control Unit
F7 30 Starter
F8 30 Heated Rear Window
F9 30 Audio Amplifier (16 Channel)
F10 - -
F11 - -
F12 - -
F13 5 Transmission Control Unit
F14 5 Engine Control Module
F15 10 Relays
F16 - -
F17 3 Door Locking Switch
F18 50 ECU Main Relay Feed
F19 40 Fuel Pump
F20 30 Seat Driver’s
F21 30 Seat Passenger’s
F22 - -
F23 5 Tilt and Microwave Sensor
F24 20 Infotainment Control Unit
F25 10 Driver’s/Passenger’s Door
Latch
F26 3 Auxiliary USB Board
F27 - -
F28 - -
F29 - -
No. Amps Circuit protected
p14.book Page 17 Tuesday, October 24, 2017 11:15 AM