Completed
Not
Completed
Comments
Completed
Not
Completed
Comments
Completed
Not
Completed
Comments
Completed
Not
Completed
Comments
Completed
Not
Completed
Comments
7.0 - Remove wheels - Ref. AA-RM-03B03-01-001
7.1 Check brake pads (replace if necessary)
8.2 Check powertrain system for leaks (engine, transmission, and exhaust)
8.3 Check all visible steering components for leaks and damage
8.4 Check engine mounts
8.5 Tighten screws, nuts, and bolts (including exhaust system, clips and strips in general)
8.6 Check torques on suspension - Ref. AA-RM-03B01-02-002/003, 03B02-01-001/002
8.7 Check condition of drive shafts
7.2 Check condition of brake discs (weigh all of them if CCM) - Ref. AA-RM-03C01-01-006
7.3 Replace electronic parking brake pads (every 2 years) - Ref. AA-RM-03C02-01-001
7.4 Check brake system for leaks/damage (bleed as required) - Ref. AA-RM-03C01-01-005
7.5 Check/clean air ducts of brake system
8.0 - Remove all under floors - Ref. AA-RM-02A04-04-001/002/003/005/006/008
8.1 Check all visible parts for routing, leaks, and damage (cooling system)
9.4 Check radiator/low temp cooler condition, check for any damage (clean as necessary)
9.5 Check transmission and clutch fluids (when mileage is not achieved) are not overfilled
9.6 Replace clutch oil and filter (only if mileage achieved) - Ref. AA-RM-04G01-01-015/021
10.0 - Lower vehicle
10.1 Replace engine oil filter - Ref. AA-RM-04F02-01-003
10.2 Fill engine oil (5 litres to start) - Ref. AA-RM-04F02-01-011
9.0 - Remove rear wheel arch liners (carry out steps 9.2 to 9.6 while oil is draining)
Replace clutch oil and filter (Every 30,000km or 20,000 miles only)
9.1 Drain engine oil - Ref. AA-RM-04F02-01-011
9.2 Check Z-bar drop links for play
9.3 Replace air filter - Ref. AA-RM-04F01-02-002
9.7 Visually check condensor area for debris
10.3 Check engine oil level - Ref. AA-RM-04F02-01-007
10.4 Top up and re-check level as required
11.0 - Lift vehicle
11.1 Visual inspection for general leaks
262
Summary of Contents for MP4-12C
