12
MX160 Zone B Output Connections
MX160 Zone B Output Connections
In a typical MX160 two Zone Audio/Video System,
Source Components can share the same Power Control
(Trigger) and Data Port Connections. The two Zones
in the MX160 share the same Audio/Video Input Con-
nections.
The MX160 Zone B Input Connection Diagram
(located on the separate folded sheet
“Mc3B”
) is an
example of a typical Zone B Second Room System.
Your system may vary from this, however the actual
components would be connected in a similar manner.
For additional information refer to “Connector and
Cable Information” on page 5.
Note: The following connections made to the MX160
are using the default settings. To make changes to
the default settings proceed to Setup Mode start-
ing on page 17.
Power Control Connections:
1. Connect a Control Cable from the MX160 POWER
CTRL (Power Control) B OUT Jack to the Power
Control In on Zone B Power Amplifier One.
2. Connect any additional Components in a similar
manner, as outlined in step 1.
Analog Audio Connections:
3. Connect Audio Cables from the MX160 Zone B
OUT - L (Left Channel) and R (Right Channel) to
Zone B Power Amplifier Left and Right respec-
tively.
Video Connections:
4. Connect a HDMI Cable from the MX160 HDMI
OUTPUT 2 Connector to the Zone B TV/Monitor
HDMI Input connector.
AC Power Cords Connections:
5. Connect the MX160 and any remaining compo-
nents’ AC Power Cords to a live AC outlet.
Proceed to Remote Control Push-buttons on
page 14.
Summary of Contents for MX160
Page 13: ...13 ...
Page 29: ...29 e XX Notes ...
Page 37: ...37 How to Operate Zone B Figure 68 ...
Page 39: ...39 Advanced Operation and Setup Figure 72 Figure 73 Figure 74 ...