McHale
R62-72 & R68-78
Twin-Rotor Rake
31
5.5 Lighting system
The 7-pin plug of the lighting system on the machine must be connected to the 7-pin
socket on the tractor.
5.6 Attaching hydraulic hosing to the tractor
There are three hydraulic hoses that must be connected to the tractor, as follows:
1.
Double-acting hydraulic function (minimum 20 l/min @ 180 bar)
2.
Single-acting hydraulic supply with float function
CAUTION: Ensure safety chains are attached to machine and tractor
Ensure the safety chains on the PTO cover sleeves are attached to both
machine and tractor to prevent them from spinning.
CAUTION: Standard PTO of 350 - 450 rpm, maximum = 450 rpm
The 540 rpm PTO speed should be selected on the tractor. The machine
should be driven at a PTO speed between 350 and 450 rpm. A PTO
speed above 450 rpm is likely to cause damage to machine
components. Do not use any faster PTO speed other than specified
above!
WARNING: Measure distance between PTO stub shafts first
Never connect a PTO shaft on a new machine/tractor combination
without first measuring the shortest distance between PTO stub shafts,
otherwise severe damage can occur.
NOTE: Check lighting system before travelling on the road
Before travelling on a public road, the operator must ensure that the
complete (tractor and machine) lighting system is in a fully functioning
condition.
WARNING: Turn off tractor and remove key before connecting
hydraulic hosing
When connecting hydraulic hosing to the tractor, ensure that the tractor
engine is turned off and that the ignition key is removed. Ensure that all
hydraulic connections are correctly tightened.