McCrometer FlowConnect FC500, Instructions Manual

Page: 1 / 17

30122-37 Rev. 1.1 | 06APR2022
Page 1
FlowConnect FC500 Retrofit Instructions
™
FlowConnect
REPLACE THIS WITH THIS
OVERVIEW OF THE PROCEDURE
This describes the procedure for retrofitting a Mc Propeller flow meter by replacing a FlowCom unit with a
FlowConnect unit at an existing remote mount location.
1 - Retrofit Procedure
STEP 1: Inventory the parts
STEP 2: Shut off or disconnect the power
STEP 3: Run replacement power and sensor
cables
STEP 4: Remove the strain relief and disconnect
the wires
STEP 5: Replace the submergible remote mount
kit at the meter head
STEP 6: Remove the FlowCom unit
STEP 7: Attach the FlowConnect unit at the
remote mount location
STEP 8: Attach the antenna
STEP 9: Connect the batteries and attach the
battery cover
STEP 10: Attach the tamper evident seals
2 - Installing Sensors and Solar Panel
1: Recommended standards
2: Installing a solar panel
3: Installing a rain gauge
4: Installing a pressure sensor
3 - Connecting Inputs and Outputs
1: Power connector
2: Inputs connector
3: Outputs connector
4 - Setting the New FlowCom Register
STEP 1: Enter PROGRAMMING MODE
STEP 2: Cycle through the first menu level
STEP 3: Cycle through the second menu level
STEP 4: Set the total
STEP 5: Exit and save settings
Retrofit Instruction: From remote mount Mc Propeller FlowCom unit to FlowConnect unit
Retrofit Instruction: From remote mount Mc Propeller FlowCom unit to
FlowConnect unit