McCrometer FlowConnect FC500, Instructions Manual

Page: 14 / 17

30122-37 Rev. 1.1 | 06APR2022
Page 14
FlowConnect FC500 Retrofit Instructions
™
FlowConnect
There are three activation points located on the
outside of the register that are used to access the
configuration menu as shown in Figure 14:
• The
P
on the far right side is used for
accessing and navigating through
the programming menu.
• The arrow at the lower right
side is used for incrementing
flashing selections.
• The arrow at the far left side is
used for moving to the next flashing selection.
Approx. 1”
Figure 14.
Magnetic
wand activation points
for configuration menu
STEP 1: Enter PROGRAMMING MODE
P





P
b. Pass the wand on the three times. The second digit
from the left will flash (Figure 16).
c. Pass the wand on the once. The display will
increment from
0
to
1
(Figure 16).
A lock code of 01000 is required to enter the
configuration menu.
P





P





3x
1x
Figure 15.
Figure 16.
Figure 17.
a. Hold the magnetic wand at the
P
on the right side
of the register. After five seconds the register will
display “Loc-codE” (Figure 15). The last digit will flash.
d. Pass the wand over the
P
to enter the lock code. The
menu selection
rAtE-Un
will appear (Figure 17). This
is the first item in the first menu level.
IMPORTANT: Be careful not to change any settings as you cycle through the menu
selections. If you accidentally make any changes, stop immediately, wait until the
configuration mode times out, and start over.
i