30122-37 Rev. 1.1 | 06APR2022
Page 7
FlowConnect FC500 Retrofit Instructions
™
FlowConnect
STEP 10: Attach the tamper evident seals
When the retrofit is completed, attach the two tamper evident seals located the base plate (Figure 8) and the battery cover
(Figure 9). There are already two other seals on the FlowConnect unit.
Each tamper evident seal is attached through the hole in the security screw and a small hole in the chassis next to the
security screw.
a. Thread the wire end through the security hole in the screw and through the hole in the chassis next to the screw.
b. When the wire is fully threaded through, insert the wire through the hole in the center of the blue lock piece, then fold
it over the top and down into the center groove.
c. Flatten the wire and snap the clasp over the blue lock piece.
Figure 8. Tamper evident seal on the
base plate
Figure 9. Tamper evident seal on the
battery cover
