21
Installation/Setup
The setup and the installation of the device must be carried out by a specialist who is familiar
with the hazards and the relevant regulations. The maintenance, operation and commissioning
of this device may only be carried out by qualified persons.
When choosing a location for your device, make sure to avoid shocks, vibration, dust, hot and
cold temperatures and dampness. Furthermore, no powerful transformers or motors must be
used close to the device.
The effect light may only be operated at a maximum ambient temperature of 45°C. The maximum
casing temperature is 60°C.
The device must be installed out of normal reach.
Illuminated objects or surfaces must be at least 0.1 m away from the device’s light emission
source. Easily flammable materials such as decorative fabrics must have a distance of at least
0.5 m to the device. Otherwise such objects may catch fire!
When setting up/installing the device, make sure that the mains cable is not squeezed or
damaged by sharp edges.
During installation or service work, the area below the place of installation must be cordoned
off.
The installation surface or mounting fixture needs to be designed in a way that it can take 10
times its load capacity for at least 1 hour without permanent damaging deformation.
Additionally, the device must be secured with a second independent safety fixture besides the
actual installation fixture when installed/set up in an elevated position. If the main support
system fails, no part of the installation must fall down.
Observe all relevant regulations of your country when mounting/installing the device.
