24
9. Operation
Always pull the mains plug before filling the fog machine.
Never fill the fog machine with flammable liquids or add such to the fog liquid. Only ever use
suitable water-based fog liquids (the CONRAD range features suitable fog liquids, see “Technical
Data”).
Never tilt the fog machine. Fog liquid may leak out or enter the inside of the device and cause
damage there or injure the operator.
Make sure that no liquid enters the inside of the device when you are filling it with fog liquid.
This can lead to damage to the device and can cause deadly electrical shocks.
• Make sure that the mains plug is not plugged in.
• Unscrew the tank cover from the device and fill fog liquid into the tank.
• If the device is set up vertically or installed on the wall, only half fill the tank in order to avoid that fog liquid leaks
out.
• Screw the tank cover firmly back into place.
• Insert the mains plug into an earthed mains socket.
• Switch the device on using the POWER ON/OFF mains switch. When the device is switched on, the mains switch
is lit and the fog machine heats up.
• The warm-up process takes about 4-5 minutes.
• Once the device has reached its operating temperature, the green indicator LED on the remote control is lit and
the device is ready for operation.
9.1 Manual Mode
• Press the green MANUAL button on the remote control.
• The device emits fog as long as you keep this button pressed.
9.2 Continuous Mode
• Press the red CONT button on the remote control.
• The device emits fog permanently and the red indicator LED is lit.
• Set the desired fog quantity using the VOLUME control.
• To deactivate permanent operation, press the red CONT button on the remote control again.
