36
■
Optional ON-OFF switch installation
2. Mark the back side of the driver-side trunk side trim
in the position shown in the figure using a punch.
3. Wrap the drill bit with duct tape as shown in the
figure.
4. Set the drill rotation to low speed.
5. With the drill bit pointed perpendicular to the
trunk side trim, drill 1.5mm holes in the marked
positions.
1.5mm hole (2 locations)
9
．
INSTALLATION OF OPTIONAL ON-OFF SWITCH FOR USE WHEN TOWING
This procedure is not necessary if the [optional on-off switch for use when towing] is not installed.
Go to 9. CAUTIONS WHEN RE-INSTALLING.
Note
Always use a drill with a rotation speed
adjustment, otherwise the rear trunk side trim
may deform.
Be careful when handling drills and other sharp
objects.
To prevent scratching and over-drilling,
always wrap the drill bit with duct tape.
CAUTION
Be careful when handling drills and other sharp
objects.
If not handled properly, it could result in serious
injury.
WARNING
Duct tape
10mm
Drill 1.5mm
Over-drilling prevention
Drill
Drill bit (shoulder)
(Drill at low speed)
Reference line
Back side of driver-side trunk side trim
Vehicle front
20mm
43mm
10mm
Punch
Center of the Optional
ON-OFF switch hole
Notch area
Trunk side trim
back side
