25
10. Disconnect the connectors.
11. Detach the wiring harness clip.
12. Remove the rear bumper.
[With blind spot monitoring system]
13. If the rear bumper is replaced, perform the blind spot
monitoring (BSM) radar test.
If the rear bumper installation position is changed
or individual differences (coating film/thickness)
occur, the blind spot monitoring control module
radar angle will deviate which could result in the
module not detecting a vehicle approaching from
the rear correctly. If the rear bumper is replaced,
perform the blind spot monitoring (BSM) radar
test.
CAUTION
Rear fender panel
Protective tape
Rear over fender
After removing rear bumper, it may hit the rear
over fender and cause a damage and/or injury.
Perform the following procedure to prevent the
rear over fender from being damaged.
―
Fix the rear over fender and rear fender
panel with protective tape.
CAUTION
Rear bumper
Connector
Clip
With rear parking sensor
