Mazda 2006 MX-5, Owner'S Manual

Page: 32 / 378

Black plate (32,1)
Installing a Child-
Restraint System
The passenger lap/shoulder belt can easily
be converted into the automatic locking
mode, which must be done to hold the
child-restraint system.
Some child-restraint systems also employ
specially designed LATCH attachments;
refer to
“
LATCH Child-Restraint
Systems
”
(page 2-23).
Follow these manufacturer's instructions
when installing a child-restraint system on
the passenger's seat, unless you are
attaching a LATCH-equipped child-
restraint system to the LATCH lower
anchors. Refer to
“
LATCH Child-
Restraint Systems
”
(page 2-23).
NOTE
Follow the child-restraint system
manufacturer's instructions carefully. If
you are not sure whether you have a
LATCH system, check in the child-
restraint system manufacturer's
instructions and follow them
accordingly. Depending on the type of
child-restraint system, it may not
employ seat belts which are in
automatic locking mode, however if it
uses an upper tether, it may not be
mounted properly in this vehicle as
there is no safe way to anchor the tether.
Confirm whether the child-restraint
system can be used with seat belts by
reading the child-restraint system
manufacturer's instructions.
Before installing a child-restraint system,
make sure the passenger air bag
deactivation indicator light illuminated by
using the key to turn the passenger air bag
off.
Refer to Passenger seat weight sensors on
page 2-37.
Refer to Passenger Air Bag Deactivation
Switch on page 2-30.
1. Make sure to remove articles from
behind the passenger seat that would
prevent the seat from sliding back fully,
and then slide the seat as far back as
possible.
2. Secure the child-restraint system with
the lap portion of the lap/shoulder belt.
See the instructions on the child-
restraint system for belt routing
instructions.
3. To get the retractor into the automatic
locking mode, pull the shoulder belt
portion of the seat belt until the entire
length of the belt is out of the retractor.
2-20
Essential Safety Equipment
Child Restraint
MX-5_8U35-EA-05F_Edition2 Page32
Tuesday, June 14 2005 2:31 PM
Form No.8U35-EA-05F