Maytag Neptune TL FAV6800A, Service

Page: 23 / 98

©2003 Maytag Appliances Company
16022808 Rev. 0 23
Troubleshooting Procedures
!
WARNING
To avoid risk of electrical shock, personal injury or death, disconnect power to unit before servicing, unless testing
requires power.
Enter / Exit Service Mode
To enter Service Mode press the Help and Back keys for
three seconds or until the control beeps. The motor
speed will be displayed when started (motor not running
display will be 0). Diagnostic codes will be shown and the
System Check or Service utility can be started. The
present state of the machine will not be changed. (i.e.,
the current cycle in progress will not be interrupted and
only the display will change).
To exit: 1) Press exit service mode , or 2) press Off , or
3) unplug the machine.
The following steps summarize special tests and features
available in Service Mode, along with methods of
activation and cancellation.
Accessing Service Tests and Diagnostic Features
while in Service Mode.
User Interface
Enter User Interface and follow the directions on screen.
This test will check the Membrane Pads and Touch
Screen. The Membrane Pad and Touch Screen Test
must be completed in approximately 10 seconds or a
failure will be shown on the display.
Quick Spin Test
While in Service Mode, select the Quick Spin Test
option.
Quick Spin test steps are as follows:
1) Lock the lid.
2) Spin to index speed 90 rpm and hold for 60 seconds.
Pump drains machine.
3) Spin to index speed 150 rpm and hold for 6 seconds.
4) Spin to index speed 350 rpm and hold for 6 seconds.
5) Spin to index speed 550 rpm and hold for 6 seconds.
6) Spin to index speed 700 rpm and hold for 6 seconds.
7) Spin to index speed 850 rpm and hold for 6 seconds.
8) Spin to index speed 1000 rpm and hold for 6
seconds.
9) Coast down to 0 rpm.
10) Unlock lid.