6
Door Magnet Installation
NOTE: Magnet buckets are shipped from the factory with the magnets in position A. The position may change based on
the door and door frame alignment on page 6.
Mount the door magnet holder on the front of the door where it will be as close as possible to the bottom of the motion
sensor but no more then 1/8" from the bottom center of the sensor (DD01E or DD01F) when the door is closed.
Select the correct slot in the magnet holder (there are three slots) to obtain 15/16" from back of sensor mounting plate
to the center of the magnet. (If you can easily slide a business card between the magnet and the DD01E or DD01F
sensor, unit is properly placed vertically.)
See image below for magnet and sensor alignment.
Screw in place with the 2 screws provided. Open and close the door to make sure that the magnet holder and motion
sensor will not interfere with normal opening and closing of the door.
See images on pages five and six.
CENTER OF MAGNET
(IN HOLDER)
MUST BE 15/16” FROM THE
SENSOR MOUNTING PLATE
SENSOR
MOUNTING
PLATE
ALIGNMENT
GUIDES
ON BOTTOM
OF DD01E
Do NOT install batteries until you are ready to test the magnet location with DD01E.
